The practical test is simple: add a few drops of food colouring to the cistern water and wait without flushing. Colour appearing in the pan points to the flush valve or siphon. A water level that keeps rising past where it should sit points to the fill valve. Checking both takes two minutes and saves a second visit.

The most common siphon failure is a split or perished diaphragm, which lets water leak back down through the siphon tube even when nobody has touched the lever, producing exactly the slow, unprompted refill that plumbers are used to diagnosing as a running toilet. Unlike a flush valve, a failing siphon usually cannot be repaired with a simple washer replacement in isolation, since the diaphragm is typically moulded as part of a plate that needs to be replaced as a unit.

A dual-flush button looks simple from the top of the cistern lid, but underneath it is doing a more complicated job than a single-flush handle ever had to. Pressing one half of the button needs to trigger a short flush, while the other half needs to lift the flush valve fully for a complete cycle, and the mechanism that makes this happen is usually either a rigid spindle or a flexible cable running down to the flush valve itself.

A close-coupled cistern bolts directly onto the back of the pan with no visible pipework between the two. Because the outlet on the cistern base sits directly above the inlet on the pan, the flush valve or siphon needs a shorter outlet and often a rubber doughnut washer to seal the joint rather than a length of pipe. Fill valves on close-coupled units tend to be shorter in the body too, since there is less depth inside a compact tank.

Before ordering, check where the existing supply pipe meets the cistern and measure the available depth if the tank is compact. Plumb2U UK stocks both side-entry and bottom-entry fill valves, including combination types that cover both configurations from one body, at trade prices for plumbers who need to match the part to the pipework rather than the other way round. Plumb2U's range, backed by next-day despatch on the common models, makes it straightforward to specify the correct entry position before the part goes in the van.

When a full lever replacement is needed, the fitting type has to match what is already there. Side levers, which mount through a hole in the side of the cistern, come in different thread diameters and in both metal and plastic bodies, and the arm length inside the tank needs to reach the flush valve or siphon without fouling the tank wall. Levers that mount through the lid, more common on close-coupled and concealed designs, connect via a spindle rather than a side arm and are not interchangeable with side-lever fittings.